signori ho una tiguan 2.0td del 2008 n.mot.CBA a cui ho sost. sensore pressione differenziale e pulito il dpf!ora dovrei effettuare la rigenerazione forzata perche la car è in recovery e nn mi permette di farla in modo passivo!con il vag com quale sarebbe la procedura??qualcuno esperto puo aiutarmi?
ATTENZIONE SE è CAMMON RAIL CAMBIA PROCEDURA 1.4l/1.9l/2.0l R4 & 2.5l R5 PD/PPD-TDI Prerequisites (General): Ignition ON Engine ON (Idle) Coolant Temperature above 50 °C (see MVB 002.4) Particle Filter Load below Specification (see MVB 075.3, VAG-COM should give the specified value) If the Particle Filter Load is above Specification the Particle Filter needs to be replaced since the car may burn down when regenerating. Power Consumers ON (Light, Seat Heating, Front/Rear Window Heater, Climate Control) Conditions (Driving Cycle): Vehicle Speed between 30-60 km/h (18-37 MPH) Engine Speed between 1500-2500 RPM (4th or 5th Gear, Automatic Transmission in Tiptronic) Duration approx. 15-20 Minutes Exhaust Gas Temperature before Turbo Charger above 700 °C Drive the car based on the above conditions until the Particle Filter Load is as low as possible (close to 0 %). In case the regeneration fails there can either be problems with the Driving Cycle Conditions or with the Engine Hardware. [Select] [01 - Engine] [Coding-II - 11] Enable Regeneration by Entering 21295. [Do It!] [Meas. Blocks - 08] Select both Groups at once 070 and 075. [Go!] MVB 070.1: Regeneration Status (xxxxxxx1 = Normal Regeneration active, xxxxxx1x = Forced Regeneration active) MVB 070.3: Regeneration Counter/Timer MVB 075.1: Exhaust Gas Temperature before Turbo Charger MVB 075.2: Exhaust Gas Temperature before Particle Filter MVB 075.3: Particle Filter Load MVB 075.4: Exhaust Gas Temperature after Particle Filter Now Start the Driving Cycle and keep watching the Measuring Blocks (2nd Person required). [Done, Go Back] [Close Controller, Go Back - 06]